Montag, 30. Mai 2016

Sentrygun UA571-C

Sentrygun 3D view, finally got around to load it up on sketchfab. Made a little mistake while exporting so the rear fins look a bit wonky. Might fix that in the future. The fins in the 3d print file are fine however since they were all exported as separate pieces to make casting possible. Will probably send it to print this week.


1 Kommentar:

  1. Hi,

    Me and a couple of friends are starting a project after the summer where we are building an auto targeting UA 571-C based on face recognition using a Raspberry PI. We are not sure yet whether to go with 3D printed parts or shape them out of foam.

    But your model looks really nice! Do you think it would be a viable base for disassembling and printing parts to construct a larger, hollow model that could be glued together an house the electronics and servos? We are sort of experienced with the robotics and programming parts of the projects but complete n00bs when it comes to 3D printing (and modelling).

    AntwortenLöschen